06.01.2012, 15:42
WSHB:
- install outer bearing into outer race; then install outer oil seal into bore of spindle support, making sure it is firmly seated.
- Carefully install spindel assembly through the outeroil seal (being careful not to dislodge seal from the bore) anf through the outer bearing.
- Place the tubular spacer and the selected shim onto the spindle shaft.
- Place the inner bearing onto the spindle shaft
- Thread tool J-24490-1 onto the spindle shaft, then install sleeve J-24490-2, and washer and nut. Tighten nut against sleeve. The spindle shaft will now be drawn through the bearings to its final installed position.
- Ready for burnout
Hab's genauso gemacht, habe mich aber wesentlich umständlicher ausgedrückt....
Günni
- install outer bearing into outer race; then install outer oil seal into bore of spindle support, making sure it is firmly seated.
- Carefully install spindel assembly through the outeroil seal (being careful not to dislodge seal from the bore) anf through the outer bearing.
- Place the tubular spacer and the selected shim onto the spindle shaft.
- Place the inner bearing onto the spindle shaft
- Thread tool J-24490-1 onto the spindle shaft, then install sleeve J-24490-2, and washer and nut. Tighten nut against sleeve. The spindle shaft will now be drawn through the bearings to its final installed position.
- Ready for burnout
Hab's genauso gemacht, habe mich aber wesentlich umständlicher ausgedrückt....
Günni