Nur heiße Luft !!!

[hubsi]

Hier in Neudeutsch eine Anleitung zum Auslesen der Fehlercodes (so sie denn 94 noch so ausgelesen werden können).

Automatic Air Condition:
Diagnostic mode = push and hold the fan "up" arrow and fan "down" arrow at the same time (5 sec.)
Push "Auto Fan" to show the fault codes
LED flash at 60 times per minute = Fault codes be stored
Reset = Remove Negative Battery Cable for 1 Minute
01+02 Temperature Door Motor Circuit Fault
03 O+04 S Outside (Ambient) Air Temperature Sensor Fault
05 O+06 S In-Vehicle Temperature Sensor Circuit Fault
07 O+08 S Solar (Sun-Load) Sensor Circuit Fault Open or Shorted
9 Low Freon Detected
10 or --- Uart or "E" and "C" Bus Failure