Jack aus Maine möchte mit seiner 66er C2 Europa bereisen - Tipps?

[Jack Panzica]

Well I celebrated Memorial Day Weekend with a little car work. I now have all the parts ready for installation .






The first thing I have to ask is , Why did I think I could do this ?



Next I had to get the transmission back in . Replaced the throw-out bearing, rear bearing and seal. Never easy...I finally resorted to the push the tail over the cross member, roll the tranny on to my chest, and do a push up with it . It went up and in. No problems but a lot of back and blue marks on my arms and body.



Drive shaft hooked up with new slip yoke



Using a jack, I lifted up the rear with cross member and bolted it to frame



Next the haft shafts...using jacks to lift the TA up to level to install HS







Next up the strut rods and spring later in the week, waiting for parts